Weider FLEX CXT 1112 - Stepper Assembly

WEIDER HEALTH and ATNESS
РАСЕ 10
STEP 10 STEPPER ASSEMBLY .
PART
NAME
sarees
ТО
prea:
21 5/16" FLAT WASHER
22 5/16" NYLON LOCK NUT
30 5/16" X 1 1/2" HEX HEAD BOLT
32 5/8" ROUND PLASTIC COVER CAP
33 1" ROUND PLASTIC COVER CAP
41 1 1/4" SQUARE END BUSHING
42 1" RING RETAINER .
43 5/8" RING RETAINER
56 5/8“ 1.0. X 11/2" BUSHING
62 #8 SHEET METAL SCREW s
[] Press 1 1/4 SQUARE END
BUSHINGS (41) into each
STEPPER PEDAL (16) and (17).
CI Double check to be certain the
' correct Pedals are on the proper
sides of the Frame (resistance
holes should be to the inside) and
then press the Pedals onto the
Pivot Tube. 32
O Press on 1" RING
RETAINERS (42)
. onto the Pivot Tube.
The teeth must be
placed so that they
face the outside of
the tube. Push the
Ring Retainer all the
way to the Pedal
forcing it snugly
against the Plastic
Bushing. (SEE
DETAIL A.).
O Cap the ends of the
Pivot Tube with 1"
ROUND PLASTIC
COVER CAPS (33).
L] Slide a s/s" X 1 12"
LD
SPACER BUSHING
(56) all the way onto
the Support Tube.
Next, assemble the
RESISTANCE
CYLINDER (58) onto
the Support Tube.
0
Press
on
a
5/8"
RING
RETAINER
-
^
443)
making.sure
Ahe.
teeth.
face
7
“the
outside
of-thé
‘Support:
Tube
and
the
Ring
is
seated
firmly
against
the
Resistance
cylinder.
Outside
inside
of
of
Tube
Tube
Ring
Retainer
DETAIL A