Weider Platinum Plus 1000 - Page 12

12
1
7
18
2
5
Attach at
t
his hole
Holes
19
44
112
17 . Orient the Rail (5) with the holes on the side
s
hown. Attach the Rail to the Upright Base (2)
with an M10 x 106mm Bolt (19) and an M10
Nylon Locknut (112). Do not overtighten the
Locknut; the Rail must be able to pivot
easily.
Tighten the Storage Knob (44) into the
Upright Base (2) and the Rail (5).
18 . Orient the Seat (25) as shown. Attach the Seat to
the Seat Carriage (16) with four M6 x 16mm
Screws (108).
25
Wide
End
16
108
108
19. Press the Front Leg Foot (38) onto the Front Leg
(4). Note: The front of the Front Leg Foot is
taller than the back of the Foot.
Attach the Front Leg (4) to the Rail (5) with four
M8 x 20mm Screws (95) and four M8 Washers
(152).
19
4
95
152
95
38
5
Front is
taller
152