Weider Pro 7500 - Page 23

23
50
52
48
97
55
55
54
54
77
2
51
48
80
56
115
77
1
51
53
77
55
80
48
51
56
55
16
97
50. Wrap the Leg Lever Cable (51) under a 90mm
Pulley (48). Attach the Pulley to the Right Base
(
1) with an M10 x 50mm Bolt (97), two Half
Guards (55), and an M10 Nylon Locknut (77).
M
ake sure the Half Guards are oriented as
shown.
51
48
97
55
55
77
51
61
51. Wrap the Leg Lever Cable (51) over a 90mm
Pulley (48). Attach the Pulley to the Double “U”
-bracket (61) with an M10 x 50mm Bolt (97),
two Half Guards (55), and an M10 Nylon
Locknut (77).
Make sure the Half Guards are
oriented as shown.
52. Wrap the Leg Lever Cable (51) under a 90mm
Pulley (48). Attach the Pulley and a Cable Trap
(56) to the Right Upright (2) with an M10 x
120mm Bolt (115), two Guards (54), an M10
Washer (80), and an M10 Nylon Locknut (77).
Tighten the Nylon Locknut only two turns.
Make sure the Cable Trap is oriented as
shown.
53. Wrap the Leg Lever Cable (51) under a 90mm
Pulley (48). Attach the Pulley and a Cable Trap
(56) to the Right Press Arm (16) with an M10 x
50mm Bolt (97), two Half Guards (55), an M10
Washer (80), and an M10 Nylon Locknut (77).
Make sure the Cable Trap is oriented as
shown.