Weifang 495 - Transporting, Installation and Unpacking

Chapter I. Transporting, Installing and
Unpacking the Diesel Engirt-e.
The front and rear lifting brac·ket· provided on the cylinder
head should be used to hang up the engine in haulage. Close atten-
tion should be paid to prevent the engine ex:teriorappearance, ac-
cessories and pipes ,etc. from damage or deformation.
,If the- engine is employed for ~tationary appiication, thefoun-
dation should be kept strong and rigid, the mounting s·urface of the
foundation surface should be kept horizontal, the driven equipment
should ,be conformed to the regulation and the working place
should be spacious ,dustproof ,rainproof and wellventilate,d.
Whe'n a new engine is unpacked before using, wipe off firstly
,the 'rust proof grease from its exposed parts ,turn crankshaft
• . ..,.- i
slowly with the staring handle; then drive the engine for 15 sec-
onds each time by means of the starting motor under decompres-
sion- condition. Repeat this operation for several times and stop the
, engine for 2 minutes after -each operation. Eventually ,start the en-
gineand run it -according to the regulation for the running'-in op-
eration.
82