Weifang 495 - Usage of the Centering Mandrel

lease bearing should be cfheck·ed and adjusted every 5'OO'operating
hO.urs (Third·orde,rmaintenance). 'Th'e 'procedure is as" follows:
Fig. 35 Usage of the centering mandrel.
Remove the. adjus ting window· cover, loosen the nuts' to adjust
the adjusting screws, When the clutch conttollever IS :shifted':to
.... ~
the differences among three clearances should not be more than
O.2mm.
(4)Thecl~tchand the power take-off shaft should' be :disl
mantled and che.cked .once ever.y·.1 000 operating' hours' ('Follrt·h·o·r~
der maintenance). Clean off th'e deposited dust and gteas.Ydirts ,in-
spectand replace the damaged parts. If" the thickness ·of· the' clut6h
lining: has been reduced to less' than 7. 2 "mm by wear, the lining
110