WEIHONG NK105 G3F - References; System Parameters Explained

Specialized Concentrated Focused
References「53」
7. References
7.1. System Parameters
7.1.1. Parameters of Operator’s Access
 Parameters Related with Velocity
Parameter
Meaning
Setting range
G00 Speed
G00 speed, which can be set in this
parameter or in the program file
Related with the specific machine tool
G00 speed < Max. velocity of machine tool
Gxx Speed
Gxx speed
Related with the specific machine tool
The max. velocity of a machine tool is related with the setting of pulse equivalent. For the detailed
expression, see Chapter 4.3.
The relation between actual feed rate and feedrate override is:
Actual feed rate= Feed rate × Feedrate override
Jog speed and rapid jog speed are set in the manual speed setup page; machining
speed, and rapid jog speed jog speed > 0.06
 Parameter Related with Machining
Parameter
Meaning
Setting range
Back REF First
Whether homing all the axes before machining is
required or not
Yes: Required
No: Not required
Lifts on Pause
Lifting amount at pause
0~10000 mm
Step Length
#variables customization
Cycle Process
Cycle Process
Whether to enable cycle process
Yes: Enabled
No: Disabled
Cycle Times
Cycle machining times  
set to 
1~9999
Cycle Interval
Interval between two adjacent cycles
0~3600000
S_Off in Intev
Whether to stop spindle in the interval
Yes: Stop
No: Not stop
G73_G83
Retract
Retract or spacing amount of G73_G83 command
0~1000000 mm
Ratio On MANU
Whether manual operation setting is influenced by
feedrate override
Yes: Influenced
No: Not influenced
Homing all the axes before machining can prevent machining deviation and ensure position accuracy.
to a machine tool to run automatically if
backing to machine origin is not executed before machining. When the home switch cannot work