Specialized Concentrated Focused
「54」References
normallyan be set to
G73_G83Retract: the retract amount after each feed under G73 command; under G83 command, the
distance between the feed plane where the cutter changes from G00 to Gxx and the previous peck
depth.
Step length: custom #variable, convenient for operators to change step length in the program file.
There are 8 groups of step length in total from the first group #STEP0 to the eighth group #STEP7
respectively. For instance, G01X=#STEP2 refers to the X axis moving the third group step length
under G01 command.
Parameters Related with Offset
Aiming at all the WCSs, used for adjusting workpiece
origin of X, Y, Z and A axes
D-value of WCS origin and MCS origin.
The relation of workpiece offset, tool offset and public offset is as following:
Workpiece coordinate = Machine coordinate - Workpiece offset Tool offset Public offset
Spindle Parameters
Whether to stop spindle at pause
Whether to stop spindle at stop
Whether to stop spindle when machining completed
Whether to turn on the red light indicator as a sign of
the completion of machining
This group of parameters sets whether to stop spindle under various forms of stop state.
File Parameters
It sets the tool lifting height of Z axis during rapid
traverse when a DXF file is being processed.
It specifies the machining depth for 2D files.
It sets whether to set the first point as workpiece origin
when a DXF file is processed.
The system will not process the next shape until the
current shape is finished.
Valve operation is enabled only when [3D cutting] is on
the workpiece surface.
It forcibly sets a dxf file using metric size.
Yes: Metric size
No: Imperial size
To Next Page
Loading...
