Proceed as follows to put the memory card back in.
1. Pull on the rubber cover to get at the slot for the memory card.
2. Push the memory card into the slot with the cut-off corner pointing upwards.
3. Briefly press on the card so that the card can engage in the device with the aid of the
spring mechanism.
4. Cover the slot for the memory card again using the rubber cover.
Caution!
When covering the memory card with the rubber cover, take care not to push in
the card accidentally, as doing so will eject it from the device. Ejecting the card may
cause loss of therapy data.
5.13 Travel with the therapy device
Traveling by air with the VENTIlogic LS/plus:
The terms of commercial transport do not currently apply to individuals who would like to
travel with the therapy device (see “3.1.5 Transport/accessories/spare parts/maintenance”
on page 34). The therapy device is currently permitted as checked baggage or hand
baggage for travel by plane under the applicable provisions for the carriage of dangerous
goods . You may take two spare batteries in hand baggage with the prior consent of the
airline company. As these regulations vary depending on the country, method of transport
or by changes in regulations, inquire with the airline company before every journey as to
which requirements are in place and which measures you must take.
You can obtain a certificate for in flight use and transportation which confirms the
electromagnetic compatibility (EMC) from the manufacturer Weinmann.
To Next Page
Loading...
Need help?
General
