weinor BiEasy 1M User Manual

© weinor GmbH & Co. KG 14 | EN © weinor GmbH & Co. KG EN | 15
Approaching the upper end position (roller blind/awning)
Press the UP button briefl y. The blind approaches the upper end
position/the awning retracts.
Approaching the upper end position (blind)
Press the UP button until the status display lights briefl y. The blind
approaches the upper end position.
Press the UP button only briefl y (jog mode on JA, pulse mode for
Combio Pulse), the blind approaches briefl y and stops again.
Intermediate positions of the blinds
Roller shutter Awning Venetian blind Interior
shading
Pos▼ Intermediate
position
Intermediate
position
Intermediate
position
Intermediate
position 1
Pos▲ Ventilation
position
-- /fabric ten-
sioning
Turning
position
Intermediate
position 2
Programming the intermediate position in the receiver
Requirement
The transmitter/transmitter channel is programmed. The end
positions of the drive have been set. The blind is in the upper end
position.
1. Move the blind to the desired position with the DOWN button.
Press and hold the DOWN button to do this.
2. Also press the STOP button. The blind stops. The status display
lights up briefl y.
The intermediate position is programmed.
Programming the ventilation/turning position in the receiver
Requirement
The transmitter/transmitter channel is programmed. The end
positions of the drive have been set. The blind is in the lower end
position.
1. Move the blind in the UP direction using the UP button until the
ventilation slots open, or the slats have turned. Keep the UP
button pressed during the movement.
2. Also press the STOP button. The blind stops. The status display
lights up briefl y.
The ventilation/turning position is programmed.
Approaching the intermediate position
Requirement
The transmitter/transmitter channel is programmed. The curtain is at
its upper end position.
1. Press the DOWN button twice briefl y. The status display lights
up briefl y.
2. The curtain travels to the stored intermediate position. In the
case of Venetian blinds, the slats turn automatically after
reaching the intermediate position if a turning position has been
programmed. If no intermediate position is programmed, the
curtain travels to the lower end position (not if Combio Pulse is
in use).
Approaching the ventilation/turning position
Requirement
The transmitter/transmitter channel is programmed. The blind is at
its lower end position.
1. Press the UP button twice briefl y. The status display lights up
briefl y.
E
x
p
lanation of functions
E
x
p
lanation of functions

weinor BiEasy 1M Specifications

General

Brand	weinor
Model	BiEasy 1M
Category	Remote Control
Language	English