© weinor GmbH & Co. KG 12 | EN © weinor GmbH & Co. KG EN | 13
display lights up briefl y. The receiver is now in programming
mode.
2. Press the programming button P on the transmitter to be
programmed until the status display lights briefl y. The receiver is
now in programming mode (ascents/descents).
3. Press the UP button immediately (within no more than 1 second)
the curtain starts moving upwards. The status display lights up
briefl y. The curtain stops briefl y, starts moving again and then
moves downwards.
4. Immediately (no more than 1 second) the curtain starts moving
downwards, press the DOWN button. The status display
lights up briefl y. The curtain stops. The transmitter channel is
programmed.
If more than 10 bidirectional receivers are being programmed in one
channel at the same time, the transmitter channel in programming
mode switches to group mode. Group mode is indicated by fast
fl ashing with pauses.
Programming in group mode is completed after a 2-minute pause or
pressing the STOP button for 6 seconds.
Note
A jogging mode for Venetian blinds for quickly reaching
receivers which are further away is not possible in a
bidirectional transmitter channel with more than 10
programmed receivers.
Synchronized programming mode
For programming one transmitter to multiple receivers at the same
time.
1. Press the DOWN and programming P (rear of the device)
buttons simultaneously (for 3 seconds) on a transmitter that has
already been programmed to the receivers. The status display
fl ashes. The receivers are now in programming mode.
2. Press the programming button P on the transmitter to be
programmed until the status display lights up briefl y. The
receivers are now in programming mode (ascents/descents).
3. Press the UP button immediately (within no more than 1 second)
the curtain starts moving upwards. The status display lights up
briefl y. The curtains stop briefl y, start moving again, stop and
then move downwards.
4. Immediately (no more than 1 second) the curtain starts moving
downwards, press the DOWN button. The status display lights
up briefl y. The curtains stop moving. The transmitter channel is
programmed.
Stopping programming mode in the transmitter
Press the STOP button and hold for at least 6 seconds until the
status display lights up orange.
Approaching end positions of roller shutter /
awning / Venetian blind
Requirement
The transmitter/transmitter channel is programmed. The end
positions of the drive have been set.
Approaching the lower end position (roller blind/awning)
Press the DOWN button briefl y. The curtain descends to the lower
end position/the awning extends fully.
Approaching the lower end position (blind)
Press the DOWN button until the status display lights briefl y. The
blind approaches the lower end position.
Press the DOWN button only briefl y (jog mode on JA, pulse mode
for Combio Pulse), the blind approaches briefl y and stops again.
To Next Page
Loading...
Need help?
General
