Part Number: 2A33687
Release Date: 8/27/2015
Revision: B
3
IMPORTANT SAFETY INFORMATION ENCLOSED. READ THIS OPERATING AND MAINTENANCE
INSTRUCTIONS MANUAL BEFORE OPERATING PRODUCT.
THIS INFORMATION MUST BE AVAILABLE TO ALL PERSONNEL THAT WILL OPERATE AND
MAINTAIN EQUIPMENT. FAILURE TO READ, UNDERSTAND AND FOLLOW THE OPERATING AND
MAINTENANCE INSTRUCTIONS MANUAL COULD RESULT IN SEVERE PERSONNEL INJURY OR
DEATH!
Most Weir SPM
®
products generate, control or direct pressurized fluids; therefore, it is critical that those who
work with these products be thoroughly trained in their proper application and safe handling. It is also critical
that these products be used and maintained properly!!
SPM
®
flow products contain elastomeric seals and are not intended to provide proper functionality when
exposed to fire.
MISUSE, SIDE LOADING, IMPROPER MAINTENANCE, OR DISASSEMBLY UNDER PRESSURE CAN
CAUSE SERIOUS INJURY OR DEATH!
The following information is given in good faith and should aid in the safe use of your SPM
®
products. This
information is not meant to replace existing Company's safety policies or practices.
Personal Responsibilities:
1. When working on Weir SPM
®
flow control products, safety glasses, approved safety shoes and hard hat
must be worn.
2. Personnel should never hammer on any component when pressure is present. Hammering on any part
or component may also cause foreign material or steel slags to become airborne.
3. It is a personal responsibility to use the proper tools when servicing the valve. It is a personal
responsibility to be knowledgeable and trained in the use and handling of tools for all maintenance of the
valve.
4. Hot surface may be present; it is a person’s own responsibility to protect against burn injury.
To Next Page
Loading...
Need help?
General
