Document P/N:
2P121260
Release Date: 02/27/2017
Revision: E
14 of 41
Lifting Requirements:
The SPM
®
TWS600S fluid end assembly with suction manifold weighs approximately 1,700 Lbs./ 771 Kg.
CAUTION: DO NOT MOUNT THE PUMP ON AN INCLINE OR VERTICALLY.
WARNING: LIFTING THE SPM
®
TWS600S PUMP AND/OR FLUID END WITHOUT USING EQUIPMENT
RATED FOR THIS LOAD CAN CAUSE EQUIPMENT DAMAGE, PERSONAL INJURY OR DEATH.
WARNING: DO NOT HANDLE, LIFT, INSTALL, OPERATE OR MAINTAIN THIS FLUID CYLINDER WITHOUT
READING THIS “OPERATION INSTRUCTION AND SERVICE MANUAL” THOROUGHLY. TRAINING IN
THESE DOCUMENTS IS A MUST FOR PACKAGERS, OPERATIONS AND MAINTENANCE PERSONNEL.
FAILURE TO DO SO CAN LEAD TO SERIOUS INJURY, DEATH, EQUIPMENT DAMAGE, PROPERTY
DAMAGE OR DAMAGE TO THE ENVIRONMENT.
NOTE: A LIFTING PLUG ASSEMBLY IS REQUIRED TO LIFT THE FLUID END. SEE TABLE BELOW FOR
PART
To Next Page
Loading...
