Weiser SMARTCODE5 - Programming User Codes

1 2
3 4
5 6
7 8
9 0
Howthekeypadworks:
Eachbuttonrepresentstwonumbers(i.e.1and2fortherstbutton).You
onlyneedtopushthebuttononcetogeteither1or2.Forexample:If
yourcodeis1-2-5-6-8,
■Pressthe
1 2
buttononcetogetnumber1.
■Pressthe
1 2
buttononcetogetnumber2.
■Thenpressthe
5 6
buttononcetogetnumber5.
■Thenpressthe
5 6
buttononcetogetnumber6.
■Finallypressthe
7 8
buttononcetogetnumber8.
1 2
3 4
5 6
7 8
9 0
6
b.Notethattheturnpieceisfunctioningproperlywhenitisslightlyawayfrom
theverticalpositionwhenlockedorslightlyawayfromahorizontalposition
whenunlocked.
8.Continued.......
a. Presstheprogrambutton on the interior unit once.
b. Enter
in4to8digitcodeontothekeypad.
c.Pressthe“LOCK”buttontosavecode.
d.
9.ProgrammingaUserCode.
● A programmed code can be from four (4) to eight (8) digits long.
●For maximum security an 8 digit code is recommended.
●Up to 2 user codes can be entered.
●Excess delay in the programming steps once started will cause unit to
beep twice and will require you to restart from step (9a) below.
Programmingthe1stusercode.
Extendtheboltbypressingthe“LOCK”buttonandre-enterthecode
to test.Theboltshouldretracttotheunlockedposition.Ifitdoesnot
unlock,repeatsteps(a)through(c).
LOCKED
LOCKED
UNLOCKED UNLOCKED
TURNPIECE
TURNPIECE
Program
Button
LOCK
Button
Continued