Welch Allyn ABPM 7100 - Technical Data and Accessories

Product description - 9
Audible signals
Individual or multiple beeps of audible signals are used. The following table explains the meaning of the
beeps:
1 beep
 Switching ON/OFF
 Starting and ending a measurement (except at night intervals)
 Removal of the interface cable
 Establishing and ending Bluetooth® communication
 Measurement errors
3 beeps
 System errors
Continuous beeps
 Severe system errors (e.g. cuff pressure is higher than 15 mmHg for longer than
10 seconds outside the measurement)
Combined beeps
 Manual deletion of measurement, 1 beep followed by 5 beeps 2 seconds later
Cuff connection
 The cuff connection is located at the top of the ABPM 7100 casing.
 The cuff is connected to the ABPM 7100 via a metal connector.
Attention
Measurement errors
 The cuff connection must always engage with an audible “CLICK“. A poor connection between the
ABPM 7100 and cuff will result in measurement errors.
The Arm Cuff
1
2
3
The arm cuff
Air tube
Air tube connection
PC Interface Cable
In order to read data from the ABPM 7100, the interface cable must be connected to an USB slot on a PC.