Maintenance
Replace the batteries
The thermometer comes with two AAA (LR03) batteries. Replace with two new AAA
(LR03) batteries when the flashing battery symbol appears on the display
1. Use a Phillips screwdriver to loosen the battery cover screw.
2. Slide open the battery cover and remove the batteries.
3. Replace the batteries. Make sure to align the batteries as indicated inside the battery
compartment.
4. Replace the battery cover and tighten the battery cover screw.
Remove the batteries before storing the thermometer for an extended period of time.
Clean and disinfect the thermometer
The thermometer can be cleaned and an intermediate-level of disinfection can be
achieved using the following method.
CAUTION Never submerge the thermometer in water or any other liquid
CAUTION Never use abrasive cleaning agents, thinners or benzene for
cleaning and never immerse the instrument in water or other cleaning
liquids.
CAUTION Never insert a sharp object into the scanner area or any other
open surface on the thermometer.
CAUTION Do not use unapproved cleaning or disinfection agents. Use of
these agents may cause damage to components.
CAUTION Do not use chemicals other than isopropyl or ethyl alcohol on
the lens.
Cleaning the sensor window
Slightly moisten a cotton swab or cloth with isopropyl or ethyl alcohol and gently wipe
the surface of the lens using a side-to-side (not circular) motion. Avoid touching the lens
except when cleaning is required.
13
To Next Page
Loading...
