INVERTER TIG PRO WELDERS (cont.)
CONTROL PANEL
Page 6
MENU ACCESS
Pushing the knob “MENU”, it is possible to select the MMA or TIG welding. The display will
show the corresponding selection. Setting the MMA welding, turning the knob “MENU”, it is
possible to select the type and diameter of the electrode or the manual mode. The display
will show the corresponding selection.
ELECTRODE SELECTION (MMA)
Once you have selected the type
and diameter of the electrode, the
onboard microcontroller self adjusts
the conguration by selecting the
corresponding value of the current to
obtain the best welding. The display
shows, rst, the electrode selected and
then, the current self-regulated.
To Next Page
Loading...
