Weldmatic 215 - Gun and Cable Assembly

Weldmatic 215Operators Manual
Model No. CP111-0, Iss A 02/05 19
Quality, Reliability, Performance
11.3 Assembly and Parts List - Gun and Cable Assembly
Fig 11 BEQ1510AO7CE (180 amp) Gun and Cable Assembly
To replace liner: Disconnect gun/cable assembly
at the Euro adaptor. Remove nozzle (1) and
head (3). Withdraw old liner from the wire-
feeder end. Insert new liner and refit
gun/cable assembly to the wirefeeder.
At the gun end, compress the liner within the
gun cable, then cut it one contact tip length
past the end of the body tube (5). Refit head,
tip and nozzle.
Item # Part # Description
1 BE4392 Nozzle Assembly
2 see ‘Tips’ Contact Tip
3 BE4335 Head
4 BE4323 Cap
5 BEQT2-30
BEQT2-45
Body Tube (2”, 30
o
)
Body Tube (2”, 45
o
)
6 BE2620054 Switch Assembly
(includes lower handle)
7 BE1880194 Handle Kit
(both halves,
includes screws)
8 BE2520007 Cap, Rigid Strain Relief
9 BE2520048 Spring, Strain Relief
10 BE2520047 Strain Relief, Euro
11 BE1199E Euro Direct Plug Kit
includes 11.1 BE4421 Large ‘O’ Ring
11.2 BE9165 Small ‘O’ Ring
12 BE43015
BE43110
BE43115X
Steel Liner 0.6 - 0.8mm
Steel Liner 0.9 - 1.2mm
Nylon Liner 0.9 - 1.2mm
Wire diameter Short series (25mm)
0.6mm BE7497
0.8mm BE7488
0.9mm BE7489
1.0mm BE7496
1.2mm BE7490
Tips
1
2
3
4
5
7
6
8
12
10 911
11a
11b