CMP203 User Guide
Unicast output setting: You should fill the unicast receiving end’s IP addresses in the
Destination IP Address box.
Destination MAC: Normally you do not need to enable the Destination MAC switch. Only in some
specific case where the unicast stream cannot be received due to unknown reasons, you can
enable Destination MAC and fill in the correct receiver MAC in instead of using unicast IP
addresses.
Constant Rate of any output channel/TS/port ought to be set manually about 2 Mbps higher
than the Effective Bitrates in the corresponding output channel / TS / port, since the Effective
Bitrates might fluctuate a little bit. If you set the Constant Rate much higher that the Effective
Bitrates, there will be lots of null packets in the output transport stream.
If you want to configure a batch of channels, please click “Batch Setting”.
Batch Setting IP output channels is also similar as setting IP input.
IP Output >Service Configuration
You can make a configuration for output services and TS.
To Next Page
Loading...