CMP203 User Guide
Check or reset Original Network ID and TS ID of each TS (frequency). Each TS should have
different IDs.
Fill the Original Network ID and TS ID of each TS (frequency) in the field of the base TS
(frequency) and then click Add to create a NIT stream for this TS (frequency).
Click +Descriptor then LCN Descriptor to check all the programs which are contained in this
frequency. Then set programs LCN.
Click +Descriptor and add the Cable Descriptor in. Then fill in the correct frequency and
symbol rate and choose the correct constellation of the TS (frequency). Then click OK. (this
operation should be set on Modulator module only).
Do same operations to add next TS (frequency) until NIT streams of all the frequencies have
been included. At last click Apply button to let all configuration take effect. Then searching
programs in your STB, you will get all programs in order of LCN which you set.
To Next Page
Loading...