When performing a test,
the BromiCharge™ gauge indicates
the approximate sodium bromide level of
the hot tub water.
To perform a water test, slide the right
wheel until the add BromiCharge™ icon
is highlighted in the middle.
There is no need to add sodium
bromide if the indicator is in the green
zone.
When adding sodium bromide, the
gauge indicator will gradually shift to
the right. When adding clean water to
the hot tub, the indicator will shift to
the left.
In order to achieve the proper level,
start pumps and add 227g (.5 lb) of
BromiCharge™ at a time and always allow
5 minutes for the gauge to react before
adding more sodium bromide.
The green zone in the center area of the
gauge should be targeted for optimal
performance.
BROMICHARGE™ LEVEL
To modify the boost level, slide the
right wheel until the boost icon is high-
lighted in the middle and use the up or
down arrow keys to adjust the level.
Click on the the level icon to confirm your
selection.
BOOST LEVEL
MODIFY THE BOOST LEVEL
Boost mode is activated automatically
5 minutes after starting a pump. Boost
mode increases the bromine genera-
tion rate to keep the water clear, clean
and soft. As a rule of thumb, its level
correspond to the number of bathers.
USER INTERFACE SMART TOUCH
73
To Next Page
Loading...
