18 WellSoft Owner’s Manual 4/7/2017
Setting The Controller
Quick Setup / Basic Settings
Iron Purge Feature
A. Hold down for about 4 seconds until the controller beeps and shows the gpg or mg/L x 10.
B. Press
until display matches your hardness or compensated hardness. (see Checklist Before You Begin)
C. Press
to store the setting and move on to the time of day setting.
Press and release
to turn on the Iron Purge Feature On/Off.
The Iron Purge feature helps to clean out iron build up in your softener. When this feature is on, the controller
will regenerate every other night. These frequent regenerations help to break up and remove iron build up. This
feature should stay turned on for 2 weeks at a time. Depending on the iron levels in your water, you should
perform this feature at least once a year.
Note: Time of day is stored in 24 hour format. (1:00 PM = 13:00)
A. Press
until the current hour is correct. Press to save the hour and move onto setting minutes.
B. Press
until the current minutes are correct. Press to store the minutes and return to home screen.
Enter The Hardness
Turn Iron Purge Feature On/off
Set Time of Day
(continued from step 1)
Step 1
Step 1
Step 2
To Next Page
Loading...
