SYSTEM INSTRUCTIONS
Sanitizing the Cold Tank:
It is strongly encouraged that all systems are sanitized using a mixture of
Hydrogen Peroxide and water prior to placing in the field. Please follow these
steps to properly perform this important step.
1. Remove two screws on rear of
top lid and remove top lid
2. Remove the cold tank lid.
3. Using ~3% concentrate
Hydrogen Peroxide, spray the
inside of the tank, lid, floats, and all parts
visible parts with a heavy mist of spray.
4. Using a clean towel or paper towel,
5. wipe the Hydrogen Peroxide away from the
surfaces.
6. Spray a light mist of spray again on all parts
and put the lid back onto the unit.
7. Allow one tank full of water to full up
and drain a single time.
8. It is strongly encouraged to perform
this step on each annual service call as
well.
To Next Page
Loading...
