CONDITIONS FOR USE
Caution
DO NOT USE WITH WATER THAT IS MICROBIOLOGICALLY UNSAFE OR OF
UNKNOWN QUALITY WITHOUT ADEQUATE DISINFECTION BEFORE OR AFTER
THE SYSTEM WAS INSTALLED.
THIS DRINKING WATER SYSTEM IS FOR USE ON POTABLE WATER SUPPLIES
ONLY.
Source Water Supply
Municipal/Private: Potable Water
Supply System Pressure: 25~100 PSI (1.7-6.9 bar)
Temperature: 40°~100°F (4°~38°C)
Warning
A pressure regulator must be installed before the system water inlet if the
water pressure or any possible pressure spikes could exceed 80 PSI (5.5
bar) Failure to comply will void all warranties. The manufacturer accepts
no liability for, and damage caused by excessive water pressure.
Environmental Conditions
System should be installed in areas that are protected from severe
environmental conditions. System is not manufactured or approved for
installation in areas that are exposed to direct sunlight, rain/snow and/or
extreme temperature variation.
Compliance
Installation and service must be performed by qualified personnel to
ensure compliance with all applicable local, state, federal and
international codes.
Note:
Always check applicable plumbing codes before tapping into a water or
drain line.
To Next Page
Loading...
