SAFETY PRECAUTIONS
Warning
Do not install or use this drinking water system where the source water is
microbiologically unsafe or with water of unknown quality without
adequate disinfection before or after the system.
Warning
A pressure regulator, such as a slow flow regulator, must be installed
before the systems water inlet if the water pressure (including any possible
spikes) could exceed 80 PSI (5.5 bar). Failure to comply will void all
warranties. The manufacturer accepts no liability for damage caused by
excessive water pressure.
Warning
These systems are manufactured with 134A refrigerant. Repairs to the
refrigeration system must be performed by a certified refrigeration
technician only.
Warning
To prevent damage fire or shock hazard, do not expose this system to rain
or other extreme elements.
Power System
Available in operating voltages of 120 V 60 Hz
Caution
- To prevent electric shock and fire hazards, do not use with other than
specified power source.
- Changes or modifications not approved by WELLSYS will void any product
warranty.
- If system begins to leak, unplug, turn off water supply and call service
center immediately.
- Before moving the system, disconnect power supply and wait for water to
reach ambient temperature before draining.
Hot water is extremely hot! Do Not dispense hot water directly to hands
directly. Hot water may cause serious injury.
- If system will not be used for an extended period (5 days or longer), drain
the system completely. Sanitize system prior to re-use. Should the system
not perform as specified, unplug, turn off water supply and call the service
center.
- Do not place any type of water container or heavy item on top of the
system.
Water may leak into the electrical system causing a fire hazard.
Heavy items may fall off causing injury.
To Next Page
Loading...
