Wen 2600-T1 User Manual

OIL RESERVOIR
(See fig. 12)
. Remove the oil cap.
. Fill the tank with a standard “Bar &
Chain Oil” available at most hardware
stores or chain saw repair/dealers.
. Replace the cil cap. IMPORTANT: All
caps must be air tight, or oil will drain out.
. Thoroughly clean off any oil that may
have spilled over onto either the front or
the rear handles.
5. When checking the oil fill level, always
return the saw to its level position.
CAUTION: .
Never operate your chain
saw when the housings or
handles are oily, or with
oily hands. TO DO SO
WOULD BE DANGEROUS.
The use of the wrong kind of lubricant could
cause damage to your saw and injury
to you.
OILER OPERATION
AUTO-OILER Model 2600 only
This model is equipped with an automatic
oiler system, which provides oil to the
guide bar and chain. The amount of oil is
controlled by rotation of the oil adjustment
knob. (See fig. 13).
For cutting jobs covering the entire length
of guide bar and very hard wood, we
recommend maximum flow (clockwise
rotation until knob stops). For jobs less
than one half length of bar medium to
minimum flow is required. One quarter
turn of the knob varies flow of oil.
MANUAL OILER All Models
The manual oiler button is located above
the trigger switch at the top of the rear
handle. To operate use only the right
thumb as shown in fig. 14.
On the Model 2600 the oiler is a con-
venience to be used for extra heavy
cutting jobs encountered without re-
adjusting the automatic oiler flow.
On the Models 5008, 5010, 5014 & 5016, it
is the only means of lubricating the saw
chain. For usage see item 9 under
OPERATING INSTRUCTIONS.
TURN TO INCREASE OIL FLOW
OPERATE OILER BUTTON
WITH THUMB ONLY.

Wen 2600-T1 Specifications

General

Brand	Wen
Model	2600-T1
Category	Chainsaw
Language	English