Wen 2600-T1 User Manual

STORAGE: Always store saw in level
position. Always store with the chain guard
scabbard in place.
Model 2600: Store with the automatic oiler
control knob turned to the minimum
position. When first using saw after
storage, turn flow control knob to its
maximum position and free run the saw
until oil is noticeable then readjust for
cutting job.
SAW CHAIN MAINTENANCE
A sharp chain will slice through the wood
with little pressure. A dull chain requires
excessive pressure to cut, causing rapid
wear of the chain, guide bar and sprocket
and overloading of the motor.
Learn to sharpen the chain correctly and
you will get easier cutting and longer life
from your saw.
Chain
sharpening
accessories
for
your
WEN
chain
saw
are
listed
under
OP-
TIONAL
EQUIPMENT,
Pages
5,
17
&
19.
RATED AMPERAGE
Models 2600-5016- :
5014-5010 12 (At 120 voits)
10 (At 120 volts)
SAW CHAIN PITCH ...
SAW CHAIN GAUGE
SHARPENING FILE
NOTES:
Replacement parts may be ordered from
the factory direct. All replacement parts
ordered will be shipped C.O.D. based on
prices in eefect on date of shipment, or,
you may request prices in advance and
include your check with the order. Be sure
to include Model Number, Part Number
and Part Description on all orders for
replacement parts.
S!
CARE OF HOUSINGS
Your WEN chain saw is double insulated
and has a durable, high impact resistant
plastic housing. When cleaning, certain
chemicals such as carbon tetrachloride,
gasoline, chlorine and ammonia must be
avoided to preserve the housing finish.
Mild soap and water will handle most of the
cleanup.
AIR CIRCULATION: Excessive accumu-
lation of sawdust inside the housing will
prevent proper cooling of the motor.
Thoroughly clean out the motor chamber
at frequent intervals by directing a jet of
compressed air into each of the housing
air vents.
This space is for your reference. On it you
will find various specifications and bits of
information concerning your chain saw.
How to order replacement parts, and a
space for your own personal notes. Keep
this booklet in a handy place. See pages
17 or 19 for the parts list.
MODEL
(See nae On Saw)
DATE PURCHASED
WHERE PURCHASED
DATE CODE ON TOOL
(6 digit no. located on bottom of tool)
MR TTT eZ
LIMITED WARRANTY
i
= pe hisatl pel pen dod pacha tgenonl feb gabe nS
20
‘or workmanahup for a penod of one
eau ol pachece Ming pele Tchasrial/Commercis) OF
rr appear eel covey te erry
direct to |
by
dolacive
seiner
dcomeoe
rss rapacious ean
it
ie Werte at Twx ete
ISAS CMOS

Wen 2600-T1 Specifications

General

Brand	Wen
Model	2600-T1
Category	Chainsaw
Language	English