Wen 2600-T1 User Manual

MAINTENANCE
CARE OF GUIDE BAR
The lower side of the guide bar will wear, in
time, from usage. You may reverse your
guide bar by placing the worn side on the
top.
After each day of use, remove the saw
chain and guide bar and clean the chips
and sawdust from the oiler holes with a
wire as shown in figure 28. If the oil hole
becomes clogged with sawdust, the oil
cannot reach and lubricate the chain.
CLUTCH TENSION
The saw is equipped with an adjustable
anti-kickback drive clutch on the drive
sprocket. If the chain should jam during a
cut, the drive sprocket can slip on its shaft.
The clutch has been pre-set at the factory
for normal use but may be adjusted if
desired. To properly adjust the clutch, the
clutch bolt should be finger tight. Then with
a hex wrench, tighten the bolt as shown in
fig. 29 for model 2600 & fig. 30 for models
5008, 5010, 5014 & 5016.
3/4 TURN
DRIVE SPROCKET REVERSAL
The sprocket of a chain saw is subject to
heavy wear. Excessive sprocket wear
causes the chain to jump or track
unevenly.
Your WEN saw has been designed so that
the sprocket can be removed and re-
versed to provide a new wear surface.
. Remove the clutch bolt and slip off the
tension washer and outer clutch
washer.
. Remove the sprocket and reverse.
. Replace the two washers and bolt.
. Tension the clutch bolt as noted in
CLUTCH TENSION (above).

Wen 2600-T1 Specifications

General

Brand	Wen
Model	2600-T1
Category	Chainsaw
Language	English