22
PROBLEM CAUSE SOLUTION
Motor will not start
Power cord damaged or not properly
plugged in.
Check the power cord, extension cord,
power plug and the power outlet. Do not
use the tool if any cord is damaged.
Defective power switch.
Stop using the tool and contact customer
service at (800) 232-1195, M-F 8-5 CST for
assistance.
Defective motor or other internal dam-
age.
Stop using the tool and contact customer
service at (800) 232-1195, M-F 8-5 CST for
assistance.
Motor or spindle stalls
Excessive cut Reduce the depth of the cut
Worn, damaged, or improperly ad-
justed drive belt
Adjust or replace the drive belt (Part No.
3424-037).
Worn spindle bearing Replace the bearing.
Excessive vibration.
Workpiece is warped, out of round,
has major flaw, or was improperly pre-
pared for turning.
Correct the problem by planing or sawing
workpiece, or discard it entirely and restart.
Worn spindle bearing. Replace the spindle bearings .
Worn drive belt. Replace the drive belt (Part No. 3424-037).
Lathe is on an uneven surface. Place the lathe on a flat surface.
Tools tend to grab or
dig in.
Dull tools. Use sharp tools.
Tool rest set too low.
Reposition the tool rest height (see page
11).
Tool rest set too far from work piece.
Reposition the tool rest closer to the work-
piece (see page 11).
Improper tool being used.
Use correct tool for operation (see page
12).
Tailstock moves when
locked and pressure is
applied.
Cam lock nut needs adjusting. Tighten cam lock nut.
Lathe bed and tailstock mating surfaces
are greasy or oily.
Remove the tailstock and clean the surfaces
with a cleaner. Apply a light coat of oil to
the lathe bed surface.
TROUBLESHOOTING
WARNING: Stop using the tool immediately if any of the following problems occur. Repairs and replace-
ments should only be performed by authorized personnel. If you have any questions, please contact our
customer service at (800) 232-1195, M-F 8-5 CST or email us at techsupport@wenproducts.com.
To Next Page
Loading...
Need help?
General
