ECO-MODE
ON OFF
MANUAL
SHUT OFF
CHOKE
RUN
OFF
Before starting the generator, check the following:
1. Place the generator outside on a dry, level surface. Allow at
least two feet of clearance on all sides of the generator.
2. Make sure all electrical devices are unplugged from the gen-
erator during ignition. Otherwise it will be difficult for the en-
gine to start.
3. To maximize safety, check that the generator is properly
grounded (see “GROUND THE GENERATOR” section).
4. Check there is sufficient level of oil in the crankcase. Add oil
if necessary (refer to “ADD / CHECK OIL” section).
5. Make sure there is sufficient level of gasoline in the fuel tank.
Add fuel if necessary (refer to “ADD / CHECK FUEL” section).
To start the generator, perform the following steps:
1. Turn the ECO-MODE (Fig. 8 - 1) switch to “OFF” during start-
ing.
2. Open the vacuum relief valve (Fig. 9) on top of fuel cap by
rotating it clockwise to the “ON” position. This will allow fuel
to flow.
3. Turn the 3-in-1 dial switch (Fig. 8 - 2) to the “CHOKE” posi-
tion.
4. Place one hand on the generator to hold it in place, and pull
on the recoil starter handle slowly until a slight resistance is
felt (Fig. 10). Then pull quickly to start the engine. Return cord
gently into the machine. Never allow the cord to snap back.
5. If engine fails to start, repeat step 4.
NOTE: After repeated failed attempts to start the engine, please
consult the troubleshooting guide before attempting again. If
problems persist please call 1-(800) 232-1195 M-F 8-5 CST.
6. After the engine has started, turn the 3-in-1 switch (Fig. 8 -
2) to the “RUN” position. The output indicator (green) will light
up.
7. Allow the generator to run for several minutes before at-
tempting to connect any electrical devices. This allows the gen-
erator to stabilize its speed and temperature.
STARTING YOUR GENERATOR
1
2
Vacuum Relief Valve
Fig. 8
Fig. 9
Fig. 10
16
To Next Page
Loading...
Need help?
General
