13
STARTING THE ENGINE
To start the generator, perform the following steps:
1. Unplug all electrical devices from the generator during ignition. Other-
wise it will be difficult for the engine to start.
2. Check that the generator is properly grounded (page 11).
3. Check the oil and fuel levels.
4. Turn the fuel valve to the ON position (Fig. 4).
5. Move the choke lever to the CLOSE/START position (Fig. 5).
6. Set the ON/OFF Switch to the ON position.
7. Pull on the recoil starter handle slowly until a slight resistance is felt, then
pull quickly to start the engine. Return cord gently into the recoil starter.
Never allow the cord to snap back.
STARTING THE GENERATOR
STOPPING THE GENERATOR
TO STOP THE GENERATOR
1. Turn off all electrical devices prior to unplugging them from the generator. Unplugging running devices can
cause damage to the generator.
2. Turn the “ON/OFF” switch to the “OFF” position.
3. Turn the fuel valve to the “OFF” (horizontal) position.
CAUTION: Allowing gasoline to sit in the fuel tank for long periods of time can make it diffi-
cult to start the generator in the future. Never store the generator for extended periods of time
with fuel in the fuel tank. Refer to Generator Storage Section.
WARNING: Allow the generator to cool for several minutes before touching areas
that become hot during use.
Fig. 5 Choke Lever
8. If engine fails to start, repeat step 7. NOTE: After repeated failed attempts to start the engine, please consult
the troubleshooting guide before attempting to start the generator. If problems persist please call (800) 232-1195,
M-F 8-5 CST.
9. Once the engine has started, slowly return the choke lever all the way to the OPEN/RUN position.
10. Allow the engine to run for several minutes before attempting to connect any electrical devices. This allows the
generator to stabilize its speed and temperature.
Fig. 4 - Fuel Valve
To Next Page
Loading...
Need help?
General
