What causes air leaking between body and drive guide on Wen 61710?
If air is leaking between the body and drive guide of your Wen Tools, it is probably due to a damaged piston O-ring or bumper. You should check these parts and replace the O-ring or bumper if necessary.
Why are fasteners driven too deep with my Wen Staple Gun?
If fasteners are being driven too deep with your Wen Staple Gun, it could be due to a worn bumper. In this case, replace the bumper. Alternatively, the air pressure might be too high; try adjusting the air pressure to a lower setting.
Why does my Wen Staple Gun run slowly or lose power?
If your Wen Staple Gun runs slowly or experiences power loss, consider these potential causes: 1. Insufficient oil. Lubricate the tool as instructed. 2. Insufficient air supply. Check the air supply to ensure it's adequate. 3. A broken spring in the cylinder cap. Replace the spring. 4. A blocked exhaust port in the cylinder cap. Replace the damaged internal parts.
Why is air leaking at the trigger area of my Wen Staple Gun?
If you notice air leaking at the trigger area of your Wen Staple Gun, it could be due to: * A damaged O-ring in the trigger valve. Check and replace the O-ring. * A damaged trigger valve head. Check and replace the trigger valve head. * A damaged trigger valve stem, seal, or O-ring. Check and replace the trigger valve stem, seal, or O-ring.
What to do if air is leaking between the body and cylinder cap of my Wen Staple Gun?
If air is leaking between the body and cylinder cap of your Wen Staple Gun, it may be due to a loose screw. Try tightening the screws. Alternatively, the seal may be damaged, in which case you should check and replace the seal.
Why is air leaking between the body and drive guide on my Wen Staple Gun?
If air is leaking between the body and drive guide of your Wen Staple Gun, it's likely due to a damaged piston O-ring or bumper. Check and replace the O-ring or bumper.
Explains symbols used in the manual for dangers and warnings.
Key precautions on servicing, understanding manual, and safe operation.
Final warnings regarding common sense, caution, and covering all situations.
Details proper lubrication procedures for the tool before and during use.
Illustrates and describes the recommended air hose and accessory connections.
To Next Page
General
