PREPARATION FOR SANDING
APPLICATIONS
• This sander is designed for use in sanding and polishing areas that are
hard to reach such as corners and edges. The pointed front allows for
easy access where other sanders cannot reach.
SELECTING THE RIGHT ABRASIVE GRIT
• Selecting the correct size and type of abrasive grit is extremely
important in achieving a high quality sanded finish. Aluminum oxide,
silicone carbide and other synthetic abrasives are best for power
sanding. To produce the best finish possible, start with a coarse grit
sandpaper and gradually change to finer and finer grit sandpaper. A final
sanding with a well-worn fine sandpaper will produce a professional
looking finish that in many cases will not need hand sanding.
ATTACHING SANDPAPER
• Disconnect sander from the power source.
• The sander uses Velco backed sandpaper that is attached to the sanding
base by simply pushing the sandpaper on to the base. There are no
retainer clips to hold the paper in place.
• To attach the sandpaper, simply align the dust extraction holes on the
base with the holes in the paper and press firmly to all segments of the
sheet ensuring a firm contact.
• Prior to attaching the sandpaper, make sure the base is free of dirt, dust
and foreign matter.
10
To Next Page
Loading...
Need help?
General
