MAINTENANCE
• Although the sander does not require user maintenance, the sander
should be kept clean. Wipe the sander with a clean cloth and periodically
blow out all areas with compressed air. Wear Safety Goggles and Dust
Mask. If compressed air is not available, use a brush to remove dust
from all areas. Do not use harsh chemicals or solvents to clean the
sander. These chemicals could seriously damage the plastic.
• Avoid overloading the sander. Overloading will result in considerable
reduction of speed and efficiency and the unit will become hot. In this
event, run the sander at a “no load” condition for a minute or two.
• Regularly inspect all mountings and screws to ensure tightness. Should
any screws become loose, tighten immediately.
• If repair is required, take the sander to an authorized service center.
S
S
A
A
V
V
E
E
T
T
H
H
E
E
S
S
E
E
I
I
N
N
S
S
T
T
R
R
U
U
C
C
T
T
I
I
O
O
N
N
S
S
!
!
12
To Next Page
Loading...
