7
AMPERAGE
REQUIRED GAUGE FOR EXTENSION CORDS
25 ft. 50 ft. 100 ft. 150 ft.
4.3 A 18 gauge 16 gauge 16 gauge 14 gauge
KNOW YOUR BELT/DISC SANDER
ASSEMBLY AND ADJUSTMENTS
UNPACKING
WARNING: To avoid injury from accidental startups, turn switch OFF and remove the plug
from the power source outlet before making any adjustments.
Carefully unpack the belt/disc sander and all its parts, and compare against the list below. Do not discard
the carton or any packaging until the belt/disc sander is completely assembled.
INCLUDES (Fig. 1)
1. Socket Head Screws (2)
2. Miter Gauge (1)
3. Washers (2)
4. Work Support (1)
5. Hex Key 15/64” (1)
6. Worktable (1)
7. Adjustment Knob (1)
WORK SUPPORT
BELT TENSION
LEVER
BELT SANDING
AREA
TRACKING
CONTROL
KNOB
MITER
GAUGE
DISC SANDING
AREA
ON/OFF
SWITCH
BASE BOLD-DOWN
AREA
DUST PORT
TABLE ANGLE
ADJUSTMENT
KNOB
DRIVE
DRUM
S A N D I N G
BELT
SANDING
DISC
To Next Page
Loading...
