16
MAINTENANCE
ROUTINE INSPECTION
Before each use, inspect the general condition of the tool. If any of these following conditions exist, do not
use until parts are replaced or the sander is properly repaired.
Check for:
• Loose hardware or improper mounting,
• Misalignment or binding of moving parts,
• Damaged cord/electrical wiring,
• Cracked or broken parts, and
• Any other condition that may affect its safe operation
CLEANING & STORAGE
1. After every operation, use a vacuum to remove dust and chips from the tool surfaces, motor housing
and work area. Keep the ventilation openings free from dust and debris to prevent the motor from over-
heating.
2. Wipe the tool surfaces clean with a soft cloth or brush. Make sure water does not get into the tool.
3. Store the tool in a clean and dry place away from the reach of children. Store sanding accessories
away from extremely hot/dry temperatures.
NOTE: Most plastics are susceptible to damage from various types of commercial solvents. Do
not use any solvents or cleaning products that could damage the plastic parts. Some of these
include but are not limited to: gasoline, carbon tetrachloride, chlorinated cleaning solvents, and
household detergents that contain ammonia.
LUBRICATION
All ball bearings are sealed and permanently lubricated. No further lubrication is required.
PRODUCT DISPOSAL
Used power tools should not be disposed of together with household waste. This product contains
electronic components that should be recycled. Please take this product to your local recycling facil-
ity for responsible disposal and to minimize its environmental impact.
WARNING:
Any attempt to repair or replace electrical parts on this tool may be hazardous.
Servicing of the tool must be performed by a qualified technician. When servicing, use only iden-
tical WEN replacement parts. Use of other parts may be hazardous or induce product failure.
WARNING:
To avoid accidents, turn OFF and unplug the tool from the electrical outlet before
cleaning, adjusting, or performing any maintenance work.
To Next Page
Loading...
Need help?
General
