SPECIFIC RULES FOR YOUR PORTABLE BAND SAW
11. MAINTAINING AND MAKING ADJUSTMENTS. Always turn off and unplug the tool before
cleaning, making adjustments or changing attachments. Accidental start-ups may occur if the tool is
plugged in during an accessory change or adjustment.
KICKBACK AND RELATED WARNINGS
Kickback is a sudden reaction to a pinched or snagged rotating wheel, backing pad, brush or any
other accessory. Pinching or snagging causes rapid stalling of the blade which in turn causes the
uncontrolled power tool to be forced in the direction opposite of the accessory’s rotation at the point
of the binding. Kickback is the result of power tool misuse and/or incorrect operating procedures or
conditions and can be avoided by taking proper precautions as given below.
1. Maintain a firm grip on the power tool and position your body and arm to allow you to resist
kickback forces. Always use auxiliary handle, if provided, for maximum control over kickback or
torque reaction during start-up. The operator can control torque reactions or kickback forces, if
proper precautions are taken.
2. Never place your hand near the blade. The accessory may kick back over your hand.
3. Do not position your body in the area where power tool will move if kickback occurs. Kickback will
propel the tool in the direction opposite to the wheel’s movement at the point of snagging.
4. Use special care when working corners, sharp edges etc. Avoid bouncing and snagging the
accessory. Corners, sharp edges or bouncing have a tendency to snag the blade and cause loss of
control or kickback.
VIBRATION SAFETY
This tool vibrates during use. Repeated or long-term exposure to vibration may cause temporary
or permanent physical injury, particularly to the hands, arms and shoulders. To reduce the risk of
vibration-related injuries:
1. First be examined by a doctor and then have regular medical check-ups to ensure medical
problems are not being caused or worsened from using this tool. People who are pregnant, have
impaired blood circulation to the hand, past hand injuries, nervous system disorders, diabetes, or
Raynaud’s disease should NOT use this tool.
2. If you feel any symptoms related to vibration (such as tingling, numbness, and white or blue
fingers), stop working and seek medical advice as soon as possible.
3. Do not smoke during use. Nicotine reduces the blood supply to the hands and fingers, increasing
the risk of vibration-related injury.
4. Wear suitable work gloves to reduce the effects of vibration.
5. Hold the tool firmly enough to keep safe control of it, but NOT too tightly. The risk associated with
vibration is increased when the gripping force is high. Let the tool do the work.
6. Take vibration-free breaks during each day of work.
These safety instructions can’t possibly warn of every scenario that may arise with this tool,
so always make sure to stay alert and use common sense during operation.
7
To Next Page
Loading...
Need help?
General
