To Next PageTo Next Page
Need help?Do you have a question about the Wen 71745 and is the answer not in the manual?
General| Type | Sliding Compound Miter Saw |
|---|---|
| Motor Power | 15 Amp |
| Max Cutting Width | 12 inches |
| Bevel Angle Range | 0-45 degrees |
| No-Load Speed | 4500 RPM |
| Max Cutting Depth at 90 Degrees | 3.5 inches |
| Arbor Size | 5/8 inches |
| Max Cutting Depth at 45 Degrees | 2.5 inches |
| Dust Port | 1.5 inches |
Keep the work area clean, well-lit, and free of hazards. Do not operate in explosive atmospheres.
Use grounded outlets, check cords, avoid wet conditions, and never modify plugs.
Stay alert, use common sense, dress appropriately, and wear personal protective equipment.
Avoid accidental starts, check for damage, do not force the tool, use guards, and never leave unattended.
Tool must be grounded via a properly installed and grounded outlet for shock protection.
Wear appropriate apparel, safety glasses, and hearing protection for tile saw use.
Steps to plug in, turn on, operate, and turn off the saw safely.
