Fig. 7B
11
ADD GASOLINE
WARNING: This pressure washer may emit highly ammable and explosive gasoline
vapors, which can cause severe burns or even death if ignited. A nearby open ame can
lead to explosion even if not directly in contact with gasoline.
Use fresh (within 30 days from purchase), lead-free gasoline with a minimum of 87 octane rating. Do not mix oil
with gasoline.
To add gasoline, follow these steps: (Fig. 8)
1. Make sure the pressure washer is on a level surface.
2. Unscrew fuel cap and set aside. NOTE: The fuel cap may be tight and hard to unscrew.
3. Slowly add unleaded gasoline to the fuel tank. Be careful not to overfill. The capacity of the fuel tank is
1.2L (0.3 gallons). NOTE: Do not fill the fuel tank to the very top. Gasoline will expand and spill over during
use even with the fuel cap in place.
4. Reinstall fuel cap and wipe clean any spilled gasoline with a dry cloth.
IMPORTANT:
• Never use an oil/gasoline mixture.
• Only use unleaded gasoline.
• Never use old gasoline.
• Avoid getting dirt or water into the fuel tank.
• Gasoline can age in the tank and make starting difficult.
Never store pressure washer for extended periods of time
with fuel in the tank.
PRESSURE WASHER PREPARATION
NOTE: After completing the above preparation, the pressure washer is ready to be started.
Fig. 8
Fig. 7A
To Next Page
Loading...
