EasyManua.ls Logo

Wen PW28

Wen PW28
26 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Before starting the pressure washer, make sure you have read and performed the steps in the “Pressure Washer
Preparation” section of this manual. If you are unsure about how to perform any of the steps in this manual
please call (800) 232-1195 M-F 8-5 CST for customer service.
DANGER: CARBON MONOXIDE.
Using a pressure washer indoors CAN KILL YOU IN MINUTES.
Pressure washer exhaust contains carbon monoxide (CO). This is a poison gas you cannot see or smell. If you
can smell the pressure washer exhaust, you are breathing CO. Even if you cannot smell the exhaust, you may be
breathing CO.
NEVER use a pressure washer inside homes, garages, crawlspaces, or other partly enclosed areas. Deadly levels
of carbon monoxide can build up in these areas. Using a fan or opening windows and doors does NOT supply
enough fresh air.
ONLY use a pressure washer outside and far away from windows, doors, and vents. These openings can pull in
pressure washer exhaust. Even if you use a pressure washer correctly, CO may leak into the home. ALWAYS use
a battery-powered or battery-backup CO alarm in the home.
If you start to feel sick, dizzy, or weak after the pressure washer has been running, move to fresh air RIGHT
AWAY. See a doctor. You may have carbon monoxide poisoning.
PRESSURE WASHER PREPARATION
CONNECTING GARDEN HOSE TO PRESSURE WASHER (Fig. 9)
1. Run water through the hose for a few seconds to flush any debris from the
hose.
2. Inspect the inlet screen and remove any debris.
3. Connect hose to water inlet and tighten by hand. There must be a
minimum of 10 feet of unrestricted hose between pressure washer and
faucet or shut off valve.
Fig. 9
CONNECT HIGH PRESSURE HOSE TO PUMP (Fig. 10)
Fig. 10
OPERATION
12
1. Attach the end of high pressure hose to the high pressure outlet on
pump.
2. Follow the same procedure with opposite end to attach high pressure
hose to spray wand.
3. Turn on water.
4. Purge the system’s pump of air by releasing the safety and squeezing
the trigger of the spray gun.

Related product manuals