Wen PW3400 - Assembly & Adjustments

ATTACHING FOOT ASSEMBLY (FIG. 1)
1. Raise or tilt pressure washer so you can line up foot with the hole
located at the center of the frame.
2. Align the rubber foot (Fig. 1 - 1) with the hole in the frame. Attach
foot by inserting the bolt from the bottom up, then attach the locking
nut (Fig. 1 - 2). Tighten the nut with a wrech until there is a slight
crush on the frame tube. Do not over tighten.
INSTALL HANDLE (FIG. 2)
Install the upper frame (Fig. 2 - 1) onto the lower frame (Fig. 2 - 2)
by sliding the handle over the two upright tubes on the lower frame
and pressing down firmly until the handle is seated and the two
detent pins snap in place.
ATTACHING UPPER AND LOWER GUN HOOKS (FIG. 3)
1. Attach the upper gun hook (Fig. 3 - 1). Align the upper gun hook
with the holes. Attach using the included nuts and bolts.
2. Attach the lower gun hook (Fig. 3 - 2). Make sure that the gun
hook is straight and correctly aligned before tightening. Wrench
tighten until the nut is snug. Do not over tighten.
ATTACHING THE SPRAY GUN (FIG. 4 & 5)
1. Screw the spray wand (Fig. 4 - 1) and the trigger handle (Fig. 4 -
2) together until they are secure.
2. Insert the inlet coupler of the spray hose (Fig. 5 - 1) into the
threaded fitting on the high pressure spray gun (Fig. 5 - 2) and
thread the black nut on by turning clockwise until it is hand tight.
Fig. 1
1
Fig. 2
1
2
Fig. 3
1
2
Fig. 4 Fig. 5
2
1
2
1
ASSEMBLY & ADJUSTMENTS
11
2