13
LEVELING THE SHOWMOBILE (CONTINUED)
THINGS TO REMEMBER WHEN OPERATING
THE WIRELESS REMOTE CONTROL
• You may have to increase the timer switch
setting during the setup procedure, if there are
interruptions.
• If the timer switch turns off before you are
finished with the remote control:
1. Turn the timer switch back on.
2. If the stabilizing jacks are already lowered
into position, you must press the red auto
level button again to regain use of the
roof/canopy raise function and the stage
function.
• Turn the transmitter switch off when not in use,
to save battery power.
• When the performance is complete, you will
probably have to turn the timer switch back on
(see the previous note) before you can close up
the Showmobile.
• Turning the transmitter switch off and on doesn’t
change anything on the Showmobile.
• If you ever need to completely disable the
hydraulic system on the Showmobile, press the
red lockout button on top of the remote control.
To activate the remote control, turn the transmit-
ter switch off and then on.
• You can lower the roof/canopy at any time by
turning the transmitter on and pressing lower
roof/canopy.
• The roof/canopy will not raise unless the chassis
is level.
Roof Limit Switch
To Next Page
Loading...