27
MAINTENANCE
STORAGE
The materials used in the manufacture of the Showmobile are generally waterproof. However, under
prolonged exposure to the elements, some of these materials may eventually show signs of decline.
Therefore, Wenger strongly encourages you to:
• Store the unit inside a building when not in use.
• Cover any components which are left outside overnight, for long periods of time, or during inclement weather.
Regular storage will protect your investment and add years to the life of the Showmobile.
REPAIR PARTS
When you contact Wenger for any repair parts for the Showmobile, be sure you know the Serial Number
of the unit (refer to the decal inside the control compartment door).
LUBRICATION
All moving parts of the Showmobile should be lubricated about twice a year. In seasonal climates, these
occasions will normally be in the spring when the Showmobile is first put into use, and again when it is
stored for the winter.
Locks
Protect all locks, locking mechanisms, keyways, and hinges with a spray-type lubricant such as WD-40,
to prevent sticking and corrosion.
Wheel Bearings
The wheel bearings of the Showmobile are greased at the factory.
They should be regreased after every 500 miles of travel,
or at least every six months:
1. Remove the rubber plug from the end cap of the wheel.
2. Lubricate the wheel bearing with an all-purpose wheel bearing grease.
3. Replace the plug.
Roof/Canopy Pivot Bearings
Once a year, lubricate the bearings on the roof/canopy
pivot points (26 grease fittings total) with an all-purpose
grease.
BATTERY
The Showmobile is equipped with a battery charger/maintainer designed to be plugged in
continuously when power is available to keep the battery charged and in peak condition.
Refer to the original Battery Charger’s Instructions received with the battery charger for
more information.
To Next Page
Loading...
