"#$%!/0!!
VACUUM OR WATER FEATURE PORT
1. Only run vacuum when dry grinding.
2. The vacuum port accepts a standard 2” vacuum hose cuff.
3. Always refer to vacuum manual.
1. Insert water feature plug in the vacuum port.
2. Ensure the blue flow control valve is in the OFF position.
3. Attach a ¾” male (standard garden hose) to a ¾” female end of the water
feature. Secure tightly with a new washer to prevent leaks.
4. Turn on water supply. Adjust the blue flow control valve as wet grinding
process requires.
!
!
!
Use extreme caution when working with electricity and water. Severe injury
or death may occur if caution is not used.!
MAINTENANCE
!
!
Disconnect power before performing any maintenance, cleaning, or repair
to your machine.
• Wipe down the machine after every job.
• Gently remove dirt and debris from the pad driver.
• Check grommets and replace if necessary.
• Vacuum, wash and thoroughly dry the underside of the machine.
• Inspect the plug ends for signs of carbon deposits and arcing.
• Check all fasteners and tighten if necessary.
• Inspect water seals around shaft for any wear or damage.
• Inspect the handle wires for damage.
• Blow off the VFD heat sink with compressed air.
• Re-install the pad drivers using blue thread locking compound.
• Using a soft scrub pad, remove any excess dirt build-up from the bottom plate
and back side of the pad drivers.
!
!
After wet operation, wash bottom of the machine thoroughly, failure to do
so may result in damaged shaft seals.
Do not use any sharp object or abrasive pad to clean the shaft seals. This
can compromise the shaft seals.
To Next Page
Loading...