"#$%!+!!
INTRODUCTION TO THE CONTROLS
!
!
!
Ensure activation lever is not depressed when plugging in the cord. If the
machine is in the START mode (lever depressed) and plugged in, the VFD will
automatically prevent the machine from running. Unplug machine, wait 5
seconds, ensure it is not in START (lever depressed), then plug in the machine.
Viper XTi/Raptor XTi: All machine operating controls are found on the handle
NOT on the keypad of the VFD.
Viper XTi/Raptor XTi: The VFD controls are locked out to avoid accidentally
changing necessary parameters.
MACHINE OPERATION
!
!
ALWAYS turn off and disconnect power from the machine when performing any
operations to the bottom of the machine. The machine and the tooling may be
hot after using.
<! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! =!
!
! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! !
! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! !
! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! !
! ! ! ! ! ! ! ! ! ! ! ! ! ! ! !!
! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! >! ! ! ! ! ! !!?!
! ! ! ! ! ! ! ! ! ! ! ! ! !!!!
! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! !!!!@!
!
!
!
A! ! ! ! ! ! ! ! ! ! ! ! ! ! ! B D !
!
@2$'!/! ! !!!!!!!!!!!!!!!!!!!!!!!!!!@2$'!8!! ! ! ! ! ! @2$'!(! ! ! ! ! ! @2$'!)!
!
!
!
6;!CD#E$%!:;;F2E$!;E!:D%!123%4!562!#EG!:D%!9#3:;4!562!
1. Unplug the power cord from the twist lock inlet (A). Ensure the handle is in its
full upright position (Fig 2). Tilt the machine back (Fig 3). Choose the
appropriate tooling holder attachment – magnetic Plug ‘N Go plate (B) for
Metal Bond tools or Foam/Velcro Adapter plate for polishing resins. Insert
the 2 shear pins through the foam pad into the rubber grommets on the pad
driver. Attach the corresponding tooling to the plate.
2. Return the machine to the upright position.
!
!
To Next Page
Loading...