AM 320-01-808
10
4. Digital Rhythm Instruments
Although the functional sequencing of the rhythm unit is
completely controlled by the co-master (CO1), the actual
sound generation takes place on the instrument board
(DSP16O), which carries the digitally stored instruments.
For internal control and processing purposes, this module
has its own microprocessor. Its audio output is applied
directly to the preamp.
5. Digital Reverb Unit
The digital reverb unit is a processor-supported "Real Time
System"; its CPU controls the A/() conversion, the digital
delay and the D/A conversion. The master controls the
reverb modes. It receives its signal from and sends the
reverberated signal to the preamp.
6. Connection Panels
The main connection panel CB45 is equipped with three
audio outputs:
- Headphones
- Audio left, Audio right
- Tape.
With the additional connection panel CB46 you
have a few additional in- and outputs at your
disposal:
- Input left/right
- Organ output left/right
- Rhythm unit output left/right
- Reverb output left/right
- Mono/Bass (organ and rhythm unit outputs com-
bined)
- Leslie output with control signals SLOW and FAST
.
To Next Page
Loading...
Need help?
General
