Weslo CADENCE 78E User Manual

3, ifthereisa plastictieintherightUpright(46),remove
theplastictie,
HoldoneoftheHandrails(59)neartherightUpright(46)
asshown,inserttheWireHarness(60)upthroughthe
hobinthebottomoftheHandrailandoutoftheround
hobinthesideoftheHandrail,ifnecessary,use
needlenoseplierstopulltheWireHarnessoutof the
hob,BecarefutnottodamagetheWireHarness.
SettheHandrail(59)ontheupperendoftheright
Upright(46),Tightena HandrailBolt(55)intotheright
HandrailandtheUprightasshown,Becarefulnotto
pinchtheWireHarness(60).
AttachtheotherHandrail(59)asdescribedabove,Note:
Therearenowiresontheleftside,
4, SettheConsoleBase(52)ontheHandrails(59),Thread
four3/4"Screws(2)intotheHandrailsandtheConsole
Base,AfteryouhavestartedallfourScrews,tightenthe
Screwsuntiltheyaresnug;do notovertightenthe
Screws.Note:it maybehelpfultopressdownonthe
topoftheConsoleBaseabovetheHandrailsasyou
tightentheScrews,
inserttheWireHarness(60)throughthetwoindicated
plastictiesontheConsoleBase(52)andupthroughthe
hobintheConsoleBaseasshown,
3
55
59
59
59
60 \
46
52
60
Ties
2
46
5, Hold the Console (65) near the Console Base (52),
Touch the right Handrail (59) to discharge any static.
insert the Wire Harness (60) through the plastic tie
labeled C in the drawing at the right, Next, locate the
connector on the Wire Harness, Hug the Wire Harness
into the connector labeled A in the drawing at the right
and in the inset drawing, The connectors shoutd slide
together easily and snap into place, if they do not,
turn the connector on the Wire Harness and try again, IF
THE CONNECTOR IS NOT INSERTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Pull any slack in the Wire Harness (60) through the plas-
tic tie labeled C, and securety tighten the plastic tie
around the Wire Harness. Cut off the end of the plastic
tie,
52
59
65
_ff

Weslo CADENCE 78E Specifications

General

Brand	Weslo
Model	CADENCE 78E
Category	Treadmill
Language	English