16. The treadmill is capable of high speeds.
A
djust the speed in small increments to
a
void sudden jumps in speed.
17. Never leave the treadmill unattended while it is
running. Always remove the key and unplug
t
he power cord when the treadmill is not in
use.
18. Do not attempt to raise, lower, or move the
treadmill until it is properly assembled. (See
ASSEMBLY on page 5, and HOW TO MOVE
THE TREADMILL on page 11.) You must be
able to safely lift 20 kg (45 lbs.) in order to
raise, lower, or move the treadmill.
19. Do not change the incline of the treadmill by
placing objects under the treadmill.
20. When folding or moving the treadmill, make
sure that the storage latch is fully closed.
21. Inspect and properly tighten all parts of the
t
readmill regularly.
22. Never drop or insert any object into any
opening.
2
3.
DANGER: A
lways unplug the power
cord immediately after use, before cleaning
the treadmill, and before performing the
maintenance and adjustment procedures
described in this manual. Never remove the
motor hood unless instructed to do so by an
authorized service representative. Servicing
other than the procedures in this manual
should be performed by an authorized ser-
vice representative only.
24. This treadmill is intended for in-home use
only. Do not use this treadmill in any com-
mercial, rental, or institutional setting.
3
WARNING: Before beginning this or any exercise program, consult your physician.
This is especially important for persons over the age of 35 or persons with pre-existing health prob-
lems. Read all instructions before using. ICON assumes no responsibility for personal injury or prop-
erty damage sustained by or through the use of this product.
SAVE THESE INSTRUCTIONS
The decals shown here have been placed
on your treadmill. If a decal is missing, or
if it is not legible, please call the toll-free
telephone number on the front cover of
this manual and order a free replacement
decal. Apply the decal in the location
shown. Note: The decals are not shown at
actual size.
To Next Page
Loading...
Need help?
General