Why does my Weslo Treadmill power turn off during use?
If your Weslo Treadmill turns off during use, check the circuit breaker located on the treadmill frame near the power cord. If it has tripped, wait five minutes, and then press the switch back in. Also, ensure the power cord is securely plugged in and that the key is fully reinserted into the console.
What to do if Weslo Treadmill power does not turn on?
If your Weslo Treadmill power does not turn on, ensure the power cord is plugged into a CUL-listed surge protector (rated at 15 amps, with a 14-gauge cord of five feet or less) that is plugged into a properly grounded outlet. Also, make sure the key is fully inserted into the console and check the circuit breaker located on the treadmill frame near the power cord. If the switch protrudes, wait five minutes, then press it back in to reset it.
How to fix Weslo Cadence Dx5 Treadmill walking belt slipping?
To fix a Weslo Treadmill walking belt that slips, first remove the key and unplug the power cord. Then, using the allen wrench, turn both rear roller adjustment bolts clockwise, 1/4 of a turn. The walking belt is correctly tightened when you can lift each side 5 to 7 cm (2 to 3 in.) off the walking platform. Ensure you keep the walking belt centered. Plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened. If the walking belt is overtightened, treadmill performance may decrease and the walking belt may be permanently damaged. Remove the key and unplug the power cord. Using the allen wrench, turn both rear roller adjustment bolts counterclockwise, 1/4 of a turn.
What to do if Weslo Cadence Dx5 Treadmill walking belt slows down when walked on?
If the Weslo Treadmill walking belt slows down when walked on, ensure you are using a CUL-listed surge protector rated at 15 amps, with a 14-gauge cord of five feet or less. If the walking belt is overtightened, remove the key and unplug the power cord. Use an allen wrench to turn both rear roller adjustment bolts counterclockwise, 1/4 of a turn. When correctly tightened, you should be able to lift each side of the belt 5 to 7 cm (2 to 3 in.) off the walking platform, keeping it centered. Plug the cord back in, insert the key, and run the treadmill for a few minutes, repeating until properly tightened.
General| Maximum Speed | 10 mph |
|---|---|
| Maximum User Weight | 250 lbs |
| Foldable | Yes |
| Display | LCD |
| Incline | 10% |
| Running Area | 50 x 16 inches |
| Programs | 6 |
To Next Page
