Westcott FJ-X2m - Mobile Application Setup and Bluetooth; Menu Screen 2 Options; Initial Mobile App Setup; Enabling Bluetooth on FJ-X2 m

Menu Selection Button Options: Screen 2
Access Screen 2 by pressing the Power | MENU button once.
1. Menu Button 1: [Lamp (icon)] Modeling Lamp On/Off
a. Press the rectangular button to the left of the group for which you wish to change the
modeling lamp or audible beep status.
b. Press the corresponding selection button for [Lamp] to turn the modeling lamp on and off.
c. The modeling lamp icon will be displayed on the screen when on.
2. Menu Button 2: [Music Note (icon)] Audible Beep On/Off
a. Press the rectangular button to the left of the group for which you wish to change the
modeling lamp or audible beep status.
b. Press the corresponding selection button for [Music] to turn the audible beep on and off.
c. A music note icon will be displayed on the screen when on.
3. Menu Button 3: [M (icon)] TTL to Manual Exposure (Group A Only)
a. Long press Menu Button 3 to convert TTL strobe output from the last shot to Equivalent
Manual Exposure.
NOTE: Control of the audible beep only applies to FJ flash models equipped with the recycle beep
functionality.
Mobile Applications (iOS & Android)
The settings of the FJ400 can be adjusted through a mobile app via the FJ-X2m Wireless Radio Trigger.
The app will also allow for different scenes to be created and saved to minimize the same setup in the
future.
Initial Setup
Before pairing the FJ-X2m with the mobile device ensure that the FJ-X2m and FJ400 are communicating
by pressing the TEST button on the FJ-X2m to fire a test shot on the FJ400.
Turn ON Bluetooth® on the FJ-X2m
1. Turn on the FJ-X2m by long-pressing the Power | MENU button.
2. Press the 2nd and 3rd Menu Selection Buttons at the same time to enter the Settings Menu.
3. Scroll down on the Selection Wheel until the Bluetooth® icon is highlighted green.
4. Press down on the Selection Wheel to highlight [OFF] and press down on the Selection Wheel
once to change the status to [ON].
5. Press OK to return to the main screen and notice the Bluetooth® icon in the bottom right-hand
corner.
NOTE: Turning off the FJ-X2m will also turn off Bluetooth® functionality and the process above will need
to be repeated upon the next start-up.
15