"3. Torque the cylinder
head
hold-down bolts.
*4.
Adjust valve
clearances.
5. Adjust the
aJtemator
and
water pump drive
belt
tension,
if
required.
6.
LiIbricate
the throttle, the
RUN
linkage
cable,
and
the transmission's
remote
control
cable.
7. Change the transmission's transmission lubricant.
8.
Adjust the
engine's
idle
speed
(1000
-1200 rpm).
ServicIng After Every
100
HoID'S
of
Operation
1.
Change the engine's lubricatlon
oD
and
oi
filter.
2. Adjust the
aItemator
and water pump
drive
belt
tension,
if
required.
ServicIng After Every
250
Hours
of
Operation
Replace
the
fuel
liter
elements
in the
OIHIngine
fuel
filter and in
the
optional
water/sediment
separator.
Servicing After Every
500
HoID'S
of
OperatIon
*1. Torque
the cylinder
head
hold-down bolts.
*2. Adjust the
valve
clearances.
"3. Crain, flush,
and
refill the fresh water cooling
system.
*4.
Check the condition of the starter motor drive pinion; lubricate
pinion.
5.
Check
the
resistance
of the glow
plugs.
NOTE:
Items
marked
by
an
asterisk
(*)
should
be performed by a
competent
mechanic.
6.
Checkthecondition
of
the sea water
pump.
Examine
the pump's
impeller
and other pump
components
for
wear.
Replace
worn components
as
needed.
7. Check the condition of the water injected exhaust elbow. Inspect for corrosion and carbon build-up,
clean as needed. Replace if corrosion is excessive.
I-.;v'IWESTERBEKE
I Engines & Generators
50
To Next Page
Loading...
Need help?
General
